DC0000002555 REV A
B
A
C
E
F
G
H
P
Q
R
S
T
I
J
L
M
N
O
U
D
A. Touch Screen
B. K-Cup® Pod Holder
C. K-Cup® Pod Holder Funnel
D. K-Cup® Pod Assembly Housing
E. Upper Drip Tray Plate
F. Upper Drip Tray
G. Lower Drip Tray Plate
H. Drip Tray Base
I. Handle
J. Lid
K. K-Cup® Pod Bin
L. Filter Mounting Bracket
M. Omnipure KQ8A Water Filter
N. RJ11 Jack
O. 3/4” Garden Hose Connector
P. Brewer Inlet Connect
Q. Drain Plugs
R. Hot Water Drain Tube
S. Cold Water Drain Tube
T. Power Switch
U. Power Cord
K-3500
™
COFFEE MAKER
DAILY
Exterior components
(e.g., drip tray)
Pod holder assembly and
needle gasket
Interior components
(e.g., drip tray)
Detach and rinse clean
Descale **
• Dispose of used K-Cup® pod
• Run a rinse brew*
• Rinse components clean
WEEKLY
QUARTERLY
* A rinse brew refers to running a hot water cycle with no K-Cup® pods. Run a rinse brew immediately after using a pod
with hot cocoa or milk ingredients. If the brewer is not used daily, run a rinse brew before brewing with a K-Cup® pod.
** Descale can be conducted before and after an extended time of storage to maximize the cleaning effectiveness.
For more instructions on cleaning or how to descale, please contact your Keurig® Authorized Distributor.
Like any kitchen appliance, Keurig® brewers need basic routines to stay clean and ensure
the best beverage experience. Below is the recommended cleaning schedule and tips.
CLEANING AREAS CLEANING METHOD
To Previous Page
Loading...
