Key Automation CT-400 - 5 Turning On and Programming the Unit; 5.1 Learning START Opening Command Times; 5.2 Times Learning with the Pedestrian Command

24
EN
5.1 Learning “START” OPENING COMMAND Times
WARNING!! The gate must be closet.
1
Put the DIP5 in ON The gate is CLOSED
2
Press the control START The gate STARTS OPENING
3
When the gate reach the opening limit switch ( FCO) the engine stops. The gate STOPS
4
Let the time goes for the time that the gate should be open. PAUSE TIME
5
Press the control START to close the gate. The gate CLOSES.
6
Wait until the gate stops. The gate is CLOSED
7
5
7
4
6
5
7
4
6
5.2 Times learning with the “PEDESTRIAN” COMMAND
WARNING!! The gate must be closed.
1
Put the DIP5 in ON The gate is CLOSED
2
Press the PARTIAL OPENING control. The gate start OPENING.
4
Press the control PARTIAL OPENING to stop the automation in the point.
Let the time goes for the time that the gate should be open.
PAUSE TIME
5
Press the PEDESTRIAN partial opening) control to start closing. The gate starts CLOSING.
6
Attendere che l’automazione si arresti automaticamente. The gate is CLOSED
7
Now the working time program is over.
Put the DIP5 in OFF and get back to the standard function
5
7
4
6
5
7
4
6
The PEDONALE (partial opening control ) can be used to permit the passage for people or small vehicles .
5 Turning on and programming the unit