Connect 2.4GHz Receiver
1
Connect Bluetooth
2
Switch toggle to 2.4GHz mode
Connect the 2.4GHz receiver to
the device USB port.
Quick Start Guide
If you are a Windows user, please find the appropriate keycaps in the box, then follow the instructions below to find and replace the following keycaps.
Press fn + 1 (for 4 seconds) and pair with
device named Keychron K1 Max.
Note: For the best wireless experience, we recommend using the
extension adapter for receiver and putting the 2.4GHz receiver
somewhere on your desk close to your keyboard for a low rate
of latency and fewer signal interferences.
Type-C
Cable
Extension Adapter
For Receiver
2.4GHz
Receiver
G = 2.4GHz
/
/
/
fn + 1
/
G / Cable / BT
G / Cable / BT
To Next Page
