Page 14
Find us at www.keysight.com
DAQM907A
Measurement Functionality
Digital I/O (Port 1,2) 16 bits, Input or Output, non-isolated
Totalizer 100 kHz Input
Analog outputs 2 channels, ± 12 V or ± 24 mA
Characteristics - typical : [1, 2, 3, 4]
DAC (output & readback)
Accuracy
Voltage ± 0.027% of output + 4.4 mV
Current ± 0.115% of output + 4.4 uA
Characteristics - nominal
DIO Port 1, 2 8 bit, input or output, nonisolated
Vin(L) < 0.8 V (TTL)
Vin(H) > 2.0 V (TTL)
Vout(L) < 0.8 V @ Iout = -400 mA
Vout(H) > 2.4 V @ Iout = 1 mA
Vin(H) max < 42 V with external open drain pull-up
Alarming Maskable pattern match or state change
Speed 4 ms (max) alarm sampling
Latency 5 ms (typical) to DAQ970A alarm output
Read/write speed 95/s
Max count 2^26 - 1
Totalize input 100 kHz (max) Rising or falling edge, programmable, min H or L time 5uS
Signal level 1 Vp-p (min) 42 Vpk (max)
Threshold 0 V or TTL, jumper selectable
Gate Input TTL-Hi, TTL-Lo, or none
Count reset Manual or Read + Reset
Read speed 85/s
DAC 1, 2 ± 12 V or ± 24 ma nonisolated
Resolution 100uV, 0.2uA
Voltage mode current 15 mA max per channel
Current mode compliance 12 V
Settling time 1 ms to 0.01% of output
1. ACAL required within the last 30 days to achieve performance accuracies.
2. ACAL assumes ± 2C with no additional TC adders.
3. Mainframe DMM - calibrated through the 901 module.
4. Standard warranted performance is 1 year, Tcal ± 5 °C
To Next Page
Loading...
Need help?
General
