1 Getting Started
24 Keysight 34980A Getting Started Guide
Installing a Module for Use with Terminal Blocks
All of the 34980A plug-in modules, except the RF and microwave modules, can be
used with a compatible terminal blocks (optional accessories 349xxT). The
optional terminal blocks provide screw terminals or solder cup connections for
your external wiring. If you plan to use an optional terminal block, follow the
procedure below.
1 Using a Pozidriv #1 screwdriver, remove the panhead grounding screw located
between the module connectors.
2 Remove the two flathead screws from the support sleeve.
3 Fit the terminal block support sleeve against the module so the openings on
the sleeve line up with the connectors and the center screw hole as shown.
4 Replace the panhead screw. Then replace and tighten the two flathead screws
to secure the sleeve to the module.
To Next Page
Loading...
