1 Getting Started
40 Keysight 34980A Getting Started Guide
Note that the key lights and continuous ac voltage measurements are made
using the internal DMM.
8 To stop the measurements, press the DMM key (in the Measure key group).
In This Example:
– You configured the internal DMM for ac voltage measurements,
– You started measurements, viewed continuous measurement results, and
stopped the measurements.
Since you didn't open or close any channels, no module or Analog Bus relays were
exercised in this example. The internal DMM acted as a stand-alone instrument
and measured whatever ac voltages happened to be present on the Analog Buses.
Pressing DMM key (in the Measure key group) also allowed you to continuously
monitor measurements on the front panel.
Menu Example: Configuring a Channel for a Measurement
Use the following instructions for any of the multiplexer modules (34921A,
34922A, 34923A, 34924A, or 34925A).
1 Make sure you have a multiplexer module installed in slot 1.
2 Using the knob to navigate or using the number keypad, select Channel 1016
(the green channel field displays 1016).
To Next Page
Loading...
