Getting Started 1
Keysight 34980A Getting Started Guide 51
5 From the Utility menu, navigate to the LAN SETTINGS choice and select
VIEW. Using the flow diagram above as a guide, view the instrument's IP
address and other LAN settings. Write down the IP address in the space below:
34980A IP Address: ___________________________
6 Press EXIT MENU.
7 Now you can use the 34980A Web Browser Interface to access and control the
instrument. See page 55 for more information on using the Web Interface.
8 If you plan to program the instrument over LAN or use such programs, make
sure you have installed the required I/O software on your computer.
9 Use the Connection Expert utility of the Keysight IO Libraries Suite to add the
34980A and verify a connection. When identifying the instrument, it is easiest
if you use the IP address noted in step 5 above. Note that if you have installed
any other I/O software, refer to documentation included with that software.
10 Now you can use various programming environments to control the 34980A.
For an overview on programming instruments via LAN, refer to the
Connectivity Guide.
Connecting Over GPIB
1 Make sure you have installed the required I/O software on your computer.
2 Follow the instructions included with your GPIB interface card to install the
GPIB hardware in your computer.
3 Connect a GPIB cable (not provided) between your computer and the 34980A.
4 Make sure power is applied to your computer and verify that the operating
system is fully booted. Then apply power to the 34980A.
5 Configure your GPIB hardware as instructed by the documentation provided
the hardware vendor.
6 Use the Connection Expert utility of the Keysight IO Libraries Suite to add the
34980A and verify a connection. Note that if you have installed any other I/O
software, refer to documentation included with that software.
7 The 34980A is shipped from the factory with a default GPIB address of 9. To
change the address, refer to the flow diagram shown below.
To Next Page
Loading...
