The CALCulate1 subsystem is enabled or disabled by the CALCulate1:STATe command. If CALCu-
late1:STATe OFF is set, no calculations are performed on the measurements, and the measurements will
flow directly to the reading memory.
If CALCulate1:STATe ON is set, only those calculations enabled by CALCulate1:SCALe:STATe, CALCu-
late1:LIMit:STATe, and CALCulate1:AVERage:STATe are performed. If enabled, scaling and offset is per-
formed first, with the results of the scaling and offset operation then being passed to the reading memory,
limit checking and statistics computations.
Histogram computation is enabled or disabled by the CALCulate2:TRANsform:HISTogram:STATe com-
mand, independent of the CALCulate1 subsystem.
Command Summary
Enable Functions
CALCulate1:STATe
CALCulate1:STATe?
CALCulate1:SMOothing:STATe
CALCulate1:SMOothing:STATe?
CALCulate1:SCALe:STATe
CALCulate1:SCALe:STATe?
CALCulate1:LIMit:STATe?
CALCulate1:LIMit:STATe?
CALCulate1:AVERage:STATe
CALCulate1:AVERage:STATe?
CALCulate2:TRANsform:HISTogram:STATe
CALCulate2:TRANsform:HISTogram:STATe?
Moving Average Filter Functions
CALCulate1:SMOothing:RESPonse
CALCulate1:SMOothing:RESPonse?
CALCulate1:SMOothing:STATe
CALCulate1:SMOothing:STATe?
Scaling (Mx-B) Functions
CALCulate1:SCALe:FUNCtion
CALCulate1:SCALe:FUNCtion?
CALCulate1:SCALe:GAIN
CALCulate1:SCALe:GAIN?
Keysight 53220A/53230A Programmer's Reference 29
CALCulate Subsystem Introduction
To Next Page
Loading...
