EasyManua.ls Logo

Keysight 53220A - Page 393

Keysight 53220A
518 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
9 Totalize 512 A totalize measurement has overflowed and rolled over.
10 Timebase error 1024 The external reference is selected, but no valid external reference
signal is present.
11 Lower Limit Failed 2048 The most recent measurement failed the lower limit test.
12 Upper Limit Failed 4096 The most recent measurement failed the upper limit test.
13 Not used 8192 (Reserved for future use)
14 Rdg Mem Overflow 16384 Reading memory is full. One or more (oldest) measurements have
been lost.
15 Not Used 32768 "0" is returned.
l To enable specific bits, you must write a decimal value that corresponds to the binary-weighted sum of
the bits in the register. The selected bits are summarized in the "Questionable Data Summary" bit (bit 3)
of the Status Byte Register.
l Use the <enable_value> parameter to specify which bits will be reported to the Status Byte. The
decimal value specified corresponds to the binary-weighted sum of the bits you wish to enable in the
register. For example, to enable bit 0 (decimal value = 1), bit 1 (decimal value = 2), and bit 12 (decimal
value = 4096), the corresponding decimal value would be 4099 (1 + 2 + 4096).
l The *CLS (clear status) command will not clear the enable register but it does clear all bits in the event
register.
l The STATus:PRESet command will clear all bits in the enable register.
l The enable register is unaffected by a Factory Reset (*RST command), or an Instrument
Preset (SYSTem:PRESet command). It is set to +32767 at power-on.
Return Format
The query reads the enable register and returns a decimal value which corresponds to the binary-
weighted sum of all bits set in the register. For example, if bit 0 (decimal value = 1) and bit 1 (decimal value
= 2) are enabled, the query will return +3.
Examples
The following example enables bit 9 (decimal value = 512) in the enable register.
STAT:QUES:ENAB 512
The following example returns which bits are enabled in the register.
STAT:QUES:ENAB?
Typical Response: +512
See Also
*STB?
STATus:QUEStionable:CONDition?
Keysight 53220A/53230A Programmer's Reference 393
STATus:QUEStionable:ENABle

Table of Contents

Other manuals for Keysight 53220A

Related product manuals