+541, "Cannot use zero as math reference for PCT, PPM, or PPB scaling functions"
+550, "Not able to execute command in local mode"
+580, "No valid external timebase"
+600, "Internal licensing error"
+601, "License file corrupt or empty"
+602, "No valid licenses found for this instrument"
+603, "Some licenses could not be installed"
+604, "License not found"
+800, "Nonvolatile memory write failure"
+810, "State has not been stored"
+820, "Model and Serial Numbers not restored"
+821, "Controller and measurement board model numbers do not match"
+822, "Controller and measurement board serial numbers do not match"
Self-Test Errors
The 53220A/230A self-test (see the *TST? command) performs a series of tests on the instrument hard-
ware. Any failure of these tests will generate a SCPI error with additional test failure information. Refer to
the Keysight 53210A/53220A/53230A 350 MHz Counter Service Guide for more information.
The following is the list of test numbers and descriptions:
+901, "Self Test failed; auto-calibration failure"
+902, "Self-test failed; main CPU power supply out of range"
+903, "Self-test failed; real time clock settings lost"
+904, "Self-test failed; main CPU error accessing boot environment"
+905, "Self-test failed; failed to read FPGA revision"
+906, "Self-test failed; FPGA revision is less than expected"
+907, "Self-test failed; PIC communication failure"
+908, "Self-test failed; battery test failed"
+909, "Self-test failed; GPIB test failed"
+910, "Self-test failed; channel 3 test failed"
+911, "Self-test failed; front panel revision check failed"
+912, "Self-test failed; measurement board test failed"
Keysight 53220A/53230A Programmer's Reference 477
SCPI Error Messages
To Next Page
Loading...
