Chapter 6: Replacing Assemblies
To replace the Intel motherboard with the ADLINK motherboard
128
25
Install the 5 short Torx T10 screws securing the motherboard to the deck.
26 Using the new Heat Sink and Fan Assembly attach the fan to the Motherboard
and Deck. Connect the fan power cable to the fan CPU fan jack. Torque fan
screws to 5 in- lb. Note: Do not use thermal grease on Heat Sink/Fan assembly.
It comes with its own thermal type material.
27 Connect the new Motherboard Switch Cable to the motherboard.
To Next Page
Loading...
