54 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
outside of its supported frequency range. Report this error to
service office.
-222 Data out of range; Value clipped to available memory.
There was insufficient memory, so a value was clipped to allow
waveform generation with the available memory. For example, OSR.
-222 Data out of range; value clipped to lower limit.
An input value is below the minimum value allowed. Examples are:
frequency setting, reference, or offset; output power; power
reference and offset; modulation depth, deviation, or modulation
source frequency; number of points and start/stop values for list
mode; start/stop values for internal I/Q calibration; sequence or
register values (save/recall); dwell time.
-222 Data out of range; value clipped to upper limit.
An input value is above the maximum value allowed. Examples:
frequency setting, reference, or offset; output power; power
reference and offset; modulation depth, deviation, or modulation
source frequency; number of points and start/stop values for list
mode; start/stop values for internal I/Q calibration; sequence or
register values (save/recall); dwell time.
-222 Data out of range; {name} clipped to lower limit.
An input value is below the minimum value allowed. In some cases
the minimum value is affected by other item setting due to
coupling.
To Next Page
Loading...
