14 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; Memory allocation error.
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; Memory catalog failed.
There is not enough memory to complete a catalog listing. Reduce
the size of any sweep lists and try again.
-321 Out of memory; Modulation subsystem unable to operate.
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; Not enough memory to buffer paging message.
There is not enough memory to buffer the asynchronous paging
message, so it will not be played. Reduce the size of any
list/sweep, and preset the source to clear up any inconsistencies.
If the problem persists, report this error to service office.
-321 Out of memory; Not enough memory to read data file.
There is not enough memory to read the specified data file. Try a
smaller file. Reduce the size of any list/sweep, and preset the
source to clear up any inconsistencies. If the problem persists
report this error to service office.
To Next Page
Loading...
