Keysight N9000A - Rear Panel; Removal; Replacement

238 Chapter 13
Assembly Replacement Procedures
Rear Panel
Rear Panel
Removal
1. Remove the instrument outer case. Refer to the Instrument Outer Case removal
procedure.
2. Refer to Figure 13-8. Using the T-10 driver, remove the twenty screws (2)
attaching the rear panel (1) to the chassis and to the reference bracket. The
rear panel can now be removed.
3. Refer to Figure 13-7. Remove W5 cable from the RF assembly. Refer to Figure
13-9. Remove W7 cable from the L.O. assembly.
NOTE If the rear panel is being replaced with a new rear panel, remove W5 and W7 at the
rear panel using a 9/16-inch nut driver.
Figure 13-8 Rear Panel Removal
Replacement
1. Reattach W5 and W7 cable depending on how you removed it.
2. Refer to Figure 13-8. Place the rear panel (1) into position in the chassis.
Replace the twenty screws (2) to attach the rear panel to the chassis. Torque to
9 inch-pounds.
3. Replace the instrument outer case. Refer to the Instrument Outer Case
replacement procedure.
1
2
W1
W4
2
2
2
W5
W7