248 Chapter 13
Assembly Replacement Procedures
Hard Disk Drive
8. Install the Programmed Hard Disk Drive to the Top Shield using precoated four
Machine Screws (0515-5074) as shown in Figure 13-15. Torque screws to
9 inch-pounds.
Figure 13-15 Top Shield/Hard Drive Assembly
9. Connect the Hard Drive ribbon cable from the Top Shield/Hard Drive/Ribbon
Cable assembly to the CPU assembly. When the ribbon cable is fully seated the
two locking tabs will grip the sides of the ribbon cable connector.
10. Install the Top Shield/Hard Drive/Ribbon Cable assembly to the CPU assembly
using fifteen precoated Machine Screws (0515-5074). Torque screws to
9 inch-pounds.
11. Refer to Figure 13-11. Replace the CPU assembly in the instrument with 6
screws. Torque to 9 inch-pounds.
To Next Page
Loading...
