3 Spectrum Analyzer Mode
3.2 Swept SA Measurement
| SDMBSE | UWBINDOOR | LTEB1M4 | LTEB3M | LTEB5M | LTEB10M | LTEB15M |
LTEB20M | WL11N20M | WL11N40M | WL11AC20M | WL11AC40M | WL11AC80M |
WL11AC160M | WL11AX20M | WL11AX40M | WL11AX80M | WL11AX160M | WL11BE20M |
WL11BE40M | WL11BE80M | WL11BE160M | WL11BE320M | WL11AD2G | WL11AY2G16 |
WL11AY4G32 | WL11AY6G48 | WL11AY8G64 | NR5GFR1B100M
[:SENSe]:RADio:STANdard[:SELect]?
Example
:RAD:STAN NONE
:RAD:STAN?
Dependencies Some selections appear only when support license is valid
Couplings By changing the radio standard, the measurement parameters will be automatically set to an
appropriate default value
State Saved Saved in instrument state
The Radio column in the table lets you specify the device to be used. It is a global
setting that affects the Device selection, between Mobile (MS) and Base Station
(BTS) settings, for all relevant PowerSuite measurements. The Device SCPI
command has the same effect as a selection in the Radio column:
Remote
Command
[:SENSe]:RADio:STANdard:DEVice BTS | MS
[:SENSe]:RADio:STANdard:DEVice?
Example
:RAD:STAN:DEV MS
:RAD:STAN:DEV?
Preset
BTS
State Saved Saved in instrument state
Range
BTS|MS
Chart for Standard and Available Measurements
Note that not every measurement in Spectrum Analyzer Mode is available for every
standard. The chart below describes which measurements are available for each
Radio Standard.
For TOI or Harmonics measurements, no Radio Standards are available.
Swept
SA
CHP OBW ACP CCDF Burst
Power
Spurious
Emission
SEM List
Sweep
None X X X X X X X X (X)
3GPP 5G NR (X) X X X X X (X)
3GPP LTE (X) X X X X X (X)
3GPP W-CDMA (X) X X X X X X (X)
GSM/EDGE (X) X X (X)
cdma2000 1x (X) X X X X X (X)
IS-95A (X) X X X X X (X)
Spectrum Analyzer Mode User's &Programmer's Reference 409
To Next Page
Loading...
