Table Of Contents
Add Secondary Module 2023
Delete Secondary Module 2023
Sync Runtime Settings (Remote Command Only) 2024
6.1.13.4 Sync Start 2024
6.1.13.5 Sync Stop 2024
6.1.13.6 Sync Connected (Remote Query Only) 2025
6.1.14 Source Preset 2025
6.2 Input 2026
6.2.1 Select Input 2026
6.2.2 RF Input Port 2035
6.2.3 SA Frequency Extender Firmware Update (Front Panel Only) 2045
6.2.4 SA Frequency Extender Cable Correction 2046
6.2.5 Half Duplex Input Port 2046
6.2.6 Port Information (Remote Command Only) 2047
6.2.7 RF Preselector 2047
6.2.8 Notch Filter 2049
6.2.9 RF Calibrator 2049
6.2.10 RF Coupling 2050
6.2.11 Input Z Correction 2052
6.2.12 All Screens Use Same Input 2053
6.2.13 External Mixer Setup 2053
6.2.13.1 Mixer Presets 2057
6.2.13.2 Mixer Bias 2062
6.2.13.3 Table Type 2063
6.2.13.4 Select VDI CCD Correction 2064
6.2.13.5 Delete All VDI CCD Corrections 2065
6.2.13.6 Harmonic 2065
6.2.13.7 LO Doubler 2066
6.2.13.8 Refresh USB Mixer Connection 2066
6.2.14 Mixer Path 2067
6.2.15 User IF Freq 2068
6.2.16 Signal ID On/Off 2068
6.2.17 Signal ID Mode 2069
6.2.18 Cable IF Loss 2070
62 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
