Table Of Contents
3.8.18.3 Reference 1174
Measurement Type 1174
Reference Power 1174
Total Power Ref 1175
PSD Ref 1175
Spectrum Pk Ref 1176
Offset/Limits Config Table 1177
3.8.18.4 Meas Standard 1177
Radio Standard 1177
Preset to Std 1178
3.8.18.5 Advanced 1180
Noise Floor Extension 1180
Enable Wideband IF for FFT 1184
3.8.18.6 Global 1184
Global Center Freq 1185
Global EMC Std 1185
Restore Defaults 1186
3.8.19 Sweep 1186
3.8.19.1 Sweep/Control 1186
Sweep/Measure 1186
Restart 1188
Pause/Resume 1191
Abort (Remote Command Only) 1191
3.8.19.2 X Scale 1192
Ref Value 1192
Scale/Div 1192
Ref Position 1193
Auto Scaling 1193
3.8.19.3 Sweep Config 1194
Points 1194
IF Dithering 1194
Image Protection 1195
3.8.20 Trace 1195
3.8.20.1 Select Trace 1195
3.8.20.2 Trace Control 1196
Trace Type 1196
Clear and Write | Restart Averaging | Restart Max/Min Hold 1201
View/Blank 1202
3.8.20.3 Math 1204
Math Function 1204
Operand 1 / Operand 2 1211
Offset 1212
Reference 1212
Short Range Comms & IoT Mode User's &Programmer's Reference 35
To Next Page
Loading...
