Command Reference
IEEE Common Commands
62
*OPC and *OPC? are currently effective only when immediately
preceded by either the :INITiate:IMMediate or a :CALibration
command.
Reset
*RST
This command presets the instrument to a factory defined
condition that is appropriate for remote programming operation.
*RST is equivalent to performing the two commands
:SYSTem:PRESet and *CLS. This command always performs a
factory preset.
Key access: > Preset
Service Request Enable
*SRE <integer>
*SRE?
This command enables the desired bits of the service request
enable register.
The query returns the value of the register, indicating which bits are
currently enabled. The default value is 255.
Example: *SRE 16
enables bits 4 in the service request enable register.
Range: Integer, 0 to 255
The preset performed by *RST is always a factory preset. That is, the same
preset performed by
:SYSTem:PRESet when :SYSTem:PRESet:TYPE is set
to
FACTory.
To Next Page
Loading...
