Command Reference
CALCulate Subsystem
78
Set Stop Frequency to the Marker Value
:CALCulate:MARKer[n][:SET]:STOP
Sets the stop frequency to the value of the active marker
frequency. In delta marker mode, the stop frequency is set to the
marker delta value. This command is not available in zero span.
Key access:
> Mkr –> Stop
Marker On/Off
:CALCulate:MARKer[n]:STATe OFF|ON|0|1
:CALCulate:MARKer[n]:STATe?
Turns the selected marker on or off.
Key access:
> Off
Marker Table On/Off
:CALCulate:MARKer:TABLe:STATe OFF|ON|0|1
:CALCulate:MARKer:TABLe:STATe?
Turns the marker table on or off
Key access:
> More > Marker Table > On/Off
Marker to Trace
:CALCulate:MARKer[n]:TRACe <integer>
:CALCulate:MARKer[n]:TRACe?
Assigns the specified marker to the designated trace.
*RST: 1
Range: 1 to 4
Key access:
> More > Marker Trace Auto 1 2 3 4
To Next Page
Loading...
