Getting Started 1
Keysight U1610/20A User’s Guide 23
Power On/Off the Handheld Scope
Press and hold for approximately 3 seconds to power on the handheld scope.
When the handheld scope display appears, the scope is ready for use.
Press and hold for approximately 3 seconds to power off the handheld scope.
The display will take some time to turn off.
Press and hold for approximately 10 seconds to power cycle the
handheld scope.
Use the Function Softkeys
Press the softkey ( to ) that corresponds to the label shown above it on
the display.
Access the Quick Help
Press any function key/softkey followed by to display its respective
Help information. Use the or key to navigate within Help.
To view Help in another language, press > >
and use the keys to select the language. Press again to exit the
selection menu.
To access information on using Help, press and hold for approximately
3 seconds.
Hook up all cables and accessories before applying power. You can connect/
disconnect probes while the handheld scope is turned on.
If the handheld scope is not able to power cycle after pressing and holding
for approximately 10 seconds, remove and reinsert the battery.
To Next Page
Loading...
Need help?
General
