4 Keysight U1610/20A User’s Guide
General Safety Information
The following general safety precautions must be observed during all phases of
operation of this instrument. Failure to comply with these precautions or with
specific warnings elsewhere in this manual violates safety standards of design,
manufacture, and intended use of the instrument. Keysight Technologies assumes
no liability for the customer’s failure to comply with these requirements.
– Remove all unused scope (oscilloscope) probes, DMM (digital
multimeter) test leads, or USB cable.
– Do not connect the DMM test leads and scope probes at the same time.
– Disconnect the scope probe from the instrument before using the DMM
functions.
– Disconnect the DMM test leads from the instrument before using the
scope functions.
To avoid electrical shock or fire during battery replacement:
– Disconnect test leads, probes, power supply, and USB cable before
opening case or battery cover.
– Do not operate the instrument with the battery cover open.
– Use only specified insulated probes and test leads.
– Use only the 10.8 V Li-Ion battery pack supplied with the instrument.
To prevent fire or injury:
– Use only the designated AC/DC adapter and test leads supplied with the
instrument.
– Observe all ratings and markings on the instrument before connecting to
the instrument.
– When performing measurements, ensure that the right safety and
performance ratings of instrument and accessories are used.
To Next Page
Loading...
Need help?
General
