Keysight u2722a - 3 Abort Subsystem; Abort:transient

3 ABORt Subsystem
28 Keysight U2722A/U2723A Programmer’s Reference
ABORt:TRANsient
Syntax
ABORt:TRANsient (@<ch>)
This command cancels any transient trigger actions and returns the transient
trigger state back to idle. It also resets the WTG transient bits in the Operation
Condition Status register.
Parameter
Remark
These commands are executed at power-on and upon execution of *RST.
Example
ABOR:TRAN (@1)
Item Type Range of values Defaul t value
<ch> NR1 1 through 3 Required parameter