Keysight u2722a - [Source:]Voltage:range

9 SOURce Subsystem
80 Keysight U2722A/U2723A Programmer’s Reference
[SOURce:]VOLTage:RANGe
Syntax
[SOURce:]VOLTage:RANGe <range>, (@<ch>)
This command sets the output voltage range. At *RST, low voltage range is
selected.
[SOURce:]VOLTage:RANGe? (@<ch>)
Queries the selected voltage range.
Parameters
Returned Query Format
<CRD>
Examples
The following command sets the output voltage range to 20 V on channel 1.
VOLT:RANG R20V, (@1)
The following query returns the programmed voltage range on channel 1.
VOLT:RANG? (@1)
Typical Response: R20V
See Also
[SOURce:]CURRent:RANGe
Item Type Range of values Default value
<ch> NR1 1 through 3 Required parameter
<range> CPD – R2V – 2 V range
– R20V – 20 V range
Required parameter