1 U8480 Series Remote Operation
70 U8480 Series Programming Guide
Using Device Clear to Halt Measurements
Device clear is an IEEE-488 low-level bus message which can be used to halt
measurements in progress. The status registers, the error queue, and all
configuration states are left unchanged when a device clear message is received.
Device clear performs the following actions:
– All measurements in progress are aborted.
– The U8480 Series returns to the trigger “idle state”.
– The U8480 Series input and output buffers are cleared.
– The U8480 Series is prepared to accept a new command string.
To Next Page
Loading...