Table Of Contents
4.2.5.1 LAN Reset 2062
4.2.5.2 Device Identification (Remote Command Only) 2062
4.2.6 Restore I/O Config Defaults 2063
4.2.7 Query USB Connection (Remote Query Only) 2063
4.2.8 USB Connection Status (Remote Query Only) 2064
4.2.9 USB Packet Count (Remote Query Only) 2064
4.2.10 Lock Remote I/O Session (Remote Command only) 2065
4.2.10.1 Lock Remote I/O Request (Remote Query only) 2066
4.2.10.2 Unlock Remote I/O Session (Remote Command only) 2067
4.2.10.3 Remote I/O Session Lock Name (Remote Query only) 2068
4.2.10.4 Remote I/O Session Lock Owner (Remote Query only) 2068
4.2.11 Multiple Network Interface Card Configuration (Remote
Commands Only) 2069
4.2.11.1 Multiple Network Adapters Enabled (Remote Query Only) 2069
4.2.11.2 Config IPV4 Address (Remote Command Only) 2070
4.2.11.3 Config IPV6 Address (Remote Command Only) 2070
4.2.11.4 List All Physical Network Adapter IP Addresses (Remote Query
Only) 2070
4.3 Preload / Unload Modes 2072
4.3.1 Power-On Mode 2072
4.3.2 Table of Modes 2073
4.3.3 Preload: Select All, Preload: Deselect All 2073
4.3.4 Move Up, Move Down 2073
4.3.5 Unload 2073
4.3.6 Loaded Modes (Remote Query Only) 2074
4.3.7 User Interface 2074
4.3.7.1 Menu Panel Position 2074
4.3.7.2 Menu Panel Tabs 2075
4.3.7.3 Annotations Local Settings/All Off 2075
4.3.7.4 Display Theme 2075
4.3.7.5 Backlight 2076
4.3.7.6 Backlight Intensity 2077
4.3.7.7 Hints 2077
52 Spectrum Analyzer Mode User's &Programmer's Reference
To Next Page
Loading...
