Programming the
Keysy remote
1. Place the Keysy remote on top of the
keycard/keyfob you wish to copy.
2. Press and hold the button you wish to
program for 6 seconds until the LED on
the Keysy remote blinks red. Release the
button and center the blinking LED on
the keycard/keyfob.
3. If the LED turns GREEN you can now
use Keysy remote as the keycard/keyfob
or follow the How to make a duplicate
section.
4. If the LED turned AMBER flip the
keycard/keyfob and repeat steps 1-3.
5. If programming continues to fail
(AMBER) move the Keysy remote to a
dierent location on the keycard/keyfob
and repeat steps 1-3.
6. If programming continues to fail after
multiple attempts the card may not
be supported. Please contact
support@tinylabs.io to troubleshoot.
Using the Keysy remote
as keycard/keyfob
1. To select the desired electronic key
press and release the previously
programmed button.
2. Hold the Keysy remote parallel to the
RFID reader (within a few centimeters).
The RFID reader should blink and/
or beep when the electronic key has
successfully been read.
3. If the Keysy remote fails to open the
door see the section Keysy Remote
Compatibility
.
GYM
GARAGE
HOME
WORK
4-BUTTON RFID REMOTE CONTROL
REPLACE THESE FOBS
WITH ONE DEVICE
For use with most
125kHz RFID systems
www.tinylabs.io/keysy
INSTRUCTIONS
Copy. Consolidate. Simplify.
Model KF-001
continued....
Keysy
remote
Rewritable
keyfob
RFID reader
not included
To Next Page
Need help?
General
