2-8
Safety Units
Warning
y Make sure to fasten the seat belt according
to the order as described so that it
functions properly.
y To prevent the seat belt from bumping
against the rear glass, unfasten the seat
belt while holding it.
y This seat belt is designed only for a
passenger who sits on the center seat in
the rear seat.
y Tug on the seat belt to make sure that the
latch plate is securely locked.
y Make sure that the seat belt is not twisted.
y Improper wearing of seat belts increases
the chance of injury or death in case of a
collision.
y Position the seat belt away from your neck
and abdomen.
Caution
y Stow the seat belt into the console when it
is not in use.
Seat belt pretensioner and
load limiter
The seat belt pretensioner and the load limiter
are the units that operate at the same time when
the driver and front passenger air bags operate,
increasing the safety effect of the seat belt and
the air bag.
Pretensioner
The seat belt pretensioner is a protection unit
that draws back the seat belt on the occupant's
chest and hips instantaneously and secures the
occupant to the seat to prevent the occupant from
bouncing forward in the event of a strong front
collision.
Danger
y The seat belt pretensioner is designed to
operate only once. After it operates, replace
the seat belt.
3
Position the shoulder belt across the body
and the lap belt as low as possible across
the hips. Insert the latch plate into the
buckle until it clicks.
4
Pull the latch plate to make sure it is securely
locked. A slack belt will greatly reduce the
protection afforded to the wearer.
5
To unfasten the seat belt, press the red
button on the buckle.
Y461_OM_EN.indb 8 2023-04-28 오전 10:55:59
To Next Page
Loading...