39
4
4
Safety features of your vehicle Child Restraint System (CRS)
To install the tether anchor:
1. Route the child restraint tether
strap over the child restraint
seatback. Route the tether strap
under the head restraint and
between the head restraint posts,
or route the tether strap over the
top of the vehicle seatback. Make
sure the strap is not twisted.
2. Connect the tether strap hook to
the tether anchor
,
then tighten
the tether strap according to the
child seat manufacturer's instruc
-
tions to firmly secure the child
restraint to the seat.
3. Check that the child restraint is
secur
ely attached to the seat by
pushing and pulling the seat for
-
ward and from side-to-side.
Securing a child restraint with a
lap/shoulder belt
When not using the LATCH system,
all child restraints must be secured
to a vehicle rear seat with the lap
part of a lap/shoulder belt.
Automatic locking mode
Since all passenger seat belts move
freely under normal conditions and
only lock under extreme or emer
-
gency conditions (emergency lock
-
ing mode), you must manually pull
the seat belt all the way out to shift
the retractor to the "automatic
locking" mode to secure a child
restraint.
The "automatic locking" mode will
help
p
revent the normal movement
of the child in the vehicle from caus
-
ing the seat belt to loosen and com
-
promise the child restraint system.
To Next Page
Loading...
