Features of your vehicle
405
Mirrors
Erasing HomeLink
buttons
1. Press and hold the button (1) and
(3) simultaneously.
The indicator (4) is turned contin
-
uously ON in orange for about 10
seconds.
Then the indicator (4) color
ch
anges to Green and flashes
rapidly.
2. Release the buttons once the
g
r
een indicator flashes.
Now HomeLink button (1), (2) and
(4)
memories are all cleared.
NVS
is a registered trademark and
Z-Nav
™
is a trademark of the Gen
-
tex Corporation, Zeeland, Michigan.
HomeLink
is a registered trade
-
mark owned by Johnson Controls,
Incorporated, Milwaukee, Wisconsin.
FCC ID: NZLZTVHL3
IC: 4112A-ZTVHL3
This device complies with Part 15
of the FCC Rules.
Operation is subject to the following
three conditions:
1. This device may not cause harm
-
ful interference, and
2. This device must accept any
inter
ference received, including
interference that may cause
undesired operation.
3. The transceiver has been tested
and c
omplies with FCC and Indus
-
try Canada rules. Changes or
modifications not expressly
approved by the party responsible
for compliance could void the
user's authority to operate the
device.
Two Way Communication Program
-
ing
1. Complete the HomeLink "Pro
-
gramming" first.
2. Before the first 10 times Home
-
Link button is pressed after the
programming, the following steps
MUST occur to program two way
communication. (only for some
older garage doors)
3. Press and release the programed
HomeLink button to activate the
garage door
.
To Next Page
Loading...
