89
6
6
Driving your vehicle Rear Cross-Traffic Collision Warning (RCCW)
䳜 Go to the 'User Settings → Driver
Assistance → Rear Cross-Traffic
Collision Warning' on the LCD dis
-
play.
The RCCW turns on and is ready to
be acti
vated when 'Rear Cross-
Traffic Collision Warning' is selected.
When the vehicle is turned off then
on
a
gain, the systems will be ready
to be activated.
When the system is initially turned
on
an
d when the vehicle is turned
off then on again, the warning light
will illuminate for 3 seconds on the
outer side view mirror.
Operating conditions
The system will activate when vehi
-
cle speed is below 6 mph (10 km/h)
and with the shift lever in R
(Reverse).
* The system will not activate when
the
v
ehicle speed exceeds 6 mph
(10 km/h). The system will acti
-
vate again when the speed is
below 6 mph (10 km/h).
The system's detecting range is
approximately 1~65 ft (0.5~20 m).
An ap
proaching vehicle will be
detected if the vehicle speed is
within 5~22.5 mph (8~36 km/h).
Note that the detec
t
ing range may
vary under certain conditions. As
always, use caution and pay close
attention to your surroundings
when backing up your vehicle.
Rear Cross-Traffic Collision Warn
-
ing (RCCW) alert
If the vehicle detected by the sen
-
sors approaches from the rear left/
right side of your vehicle, the warn
-
ing chime will sound, the warning
light on the outer side view mirror
will blink and a message will appear
on the LCD display.
Left
Right
If the rear view monitor system is in
activation, a message will also
appear on the instrument cluster or
multimedia screen.
The warning will stop when:
To Next Page
Loading...
