23
7
7
What to do in an emergency If you have a flat tire (with Tire Mobility Kit)
2. Connect the filling hose (3) of the
compressor (clip mounted side)
directly and then connect the fill
-
ing hose (3) (opposite side) to the
tire valve.
3. Connect between compressor and
the
v
ehicle power outlet using the
cable and connectors.
4. Adjust the tire inflation pressure
to the c
old tir
e recommended
pressure as indicated on the vehi
-
cle's placard or tire inflation pres
-
sure label located on the driver's
side center pillar outer panel. (In
this owner's manual, refer to
"Tires and wheels" on page 9-4.)
䳜 T
o increase the inflation pres
-
sure, switch on the compressor,
position I. To check the current
inflation pressure setting,
briefly switch off the compres
-
sor.
The pressure gauge may show
higher than actual reading when the
compressor is running. To get an
accurate tire reading, the compres
-
sor needs to be turned off.
Do not let the compressor run for
more than 10 minutes; otherwise,
the device may overheat and be
damaged.
䳜 To reduce the inflation pres
-
sure, press the button (9) on
the compressor.
Tire pressure sensor
When you use the Tire Mobility Kit
including sealant not approved by
Kia, the tire pressure sensors may
be damaged by sealant. The sealant
on the tire pressure sensor and
wheel should be removed when you
replace the tire with a new one and
inspect the tire pressure sensors at
an authorized dealer.
To Next Page
Loading...
