Kia 2020 Telluride - Driving Info Display; Service Mode

81
4
4
Features of your vehicleLCD displays
Service Mode
This mode reminds you of scheduled
maintenance information.
Service in
It calculates and displays when you
need a scheduled maintenance ser
-
vice (mileage or days).
If the remaining mileage or time
reaches 900 miles (1,500 km) or 30
days, "Service in" message is dis
-
played for several seconds each
time you set the ENGINE START/
STOP button to the ON position.
Service required
If you do not have your vehicle ser -
viced according to the already
inputted service interval, "Service
required" message is displayed for
several seconds each time you set
the ENGINE START/STOP button to
the ON position.
To reset the service interval to the
mileage and days that were previ
-
ously inputted:
󳱽Press the OK button (Reset) for
more than 1 second.
NOTICE
If any of the following conditions
occurs, the mileage and days may
be incorrect.
󳱽The battery cable is disconnected.
󳱽The battery is discharged.
Driving info display
At the end of each driving cycle, the
Driving Info message is displayed.
This display shows the trip distance
(1), average energy consumption
(2), driving time (3).
This information is displayed for a
few seconds when you turn off the
vehicle, and then goes off automati
-
cally. The information is calculated
for each time the vehicle is turned
on.
NOTICE
󳱽If sunroof open warning is dis -
played in the cluster, the Driving
Information message may not be
displayed.
OON048117NR
on_en_us.book Page 81 Thursday, January 31, 2019 2:23 PM