Kia 2020 Telluride - Blind-Spot View Monitor (BVM) System; To Turn off BVM; To Turn on BVM

109
4
4
Features of your vehicleBlind-spot View Monitor (BVM) system
Blind-spot View Monitor (BVM)
system (if equipped)
The Blind-spot View Monitor (BVM)
system displays the passenger-side
rear areas in the cluster when the
system is activated.
To turn on BVM
When the BVM is enabled in the set -
tings.
1.ENGINE START/STOP button is in
the ON position.
2.The turn signal is activated.
To turn off BVM
1.ENGINE START/STOP button is in
the OFF position.
2.The turn signal is deactivated.
3.Other warning screen pops up and
takes priority over the BVM.
WARNING
Like all assistance system, BVM
system has limitations. Sole-reli
-
ance on the system may result in a
collision.
WARNING
󳱽ALWAYS look around your vehicle
to make sure there are no objects
or obstacles before moving the
vehicle in any direction to prevent
a collision.
󳱽Objects are closer than they
appear. Failure to visually confirm
that is safe to change the lane
before doing so may result in
crash and serious injury or death.
󳱽Always keep the camera lens
clean. The camera may not work
normally if the lens is covered
with foreign material.
OON048102NR
on_en_us.book Page 109 Thursday, January 31, 2019 2:23 PM