Kia 2020 Telluride - Auto Defogging System (ADS) (Only

Features of your vehicle
1544
Windshield defrosting and defogging
Canceling/returning automatic
defogging logic on automatic cli
-
mate control system
1.Turn the ENGINE START/STOP
button to the ON position.
2.Press the defroster button ().
3.While pressing the air conditioning
(A/C) button, press the air intake
control button at least 5 times
within 3 seconds.
The recirculation indicator blinks 3
times in 0.5 second of intervals. It
indicates that the defogging logic
is canceled or returned to the
programmed status.
If the battery has been discharged
or disconnected, it resets to the
defog logic status.
Auto Defogging System (ADS) (only
for automatic climate control sys
-
tem) (if equipped)
The Auto Defogging System (ADS)
reduces the probability of fogging
up the inside of the windshield by
automatically sensing the moisture
inside the windshield.
The ADS operates when the heater
or air conditioning is on.
The indicator illuminates when the
ADS senses the moisture on the
inside of the windshield and oper
-
ates.
The ADS addresses excess moisture
on the inside of the windshield in
stages. For example if auto defog
-
ging does not defog inside the wind -
shield at step 1, it tries to defog
again at step 2.
1.Outside air position
2.Operating the air conditioning
3.Increasing air flow toward the
windshield
4.Blowing air flow toward the wind
-
shield
OON048334NR
OON048407NR
on_en_us.book Page 154 Thursday, January 31, 2019 2:23 PM