Driving your vehicle
245
All Wheel Drive (AWD) system
Mud or snow
If one of the front or rear wheels
begins to spin in mud, snow, etc. the
vehicle can sometimes be driven out
by engaging the accelerator pedal
further; however avoid running the
engine continuously at high rpm
because doing so could damage the
AWD system.
Driving in sand or mud
Maintain slow and constant
speed. Operate the accelerator
pedal slowly to ensure safe driv
-
ing (wheel-slip prevention).
Use tire chains driving in mud if
necessary.
Keep sufficient distance between
your vehicle and the vehicle in
front of you.
Reduce vehicle speed and always
check the road condition.
Avoid speeding, rapid acceleration,
sudden brake applications, and
sharp turns to prevent getting
stuck.
When the vehicle is stuck in snow,
sand or mud, the tires may not
operate.
This is to protect the transmis
-
sion and not a malfunction.
Moving the car forcibly to get out of
mud or sand can cause damage/
overheat of the engine or damage/
breakdown of the transaxle, differ
-
ential or 4WD system as well as
damage to tires. If excessive wheel
slip occurs after entering a sandy/
muddy road, the vehicle may fall
into the sand/mud. When it hap
-
pens, put a stone or a tree branch
under the tire, and then try to pull
out the car, or try to get it unstuck
by repeatedly moving forwards and
backwards.
Your vehicle is equipped with tires
designed to provide safe ride and
handling capability. Do not use a size
and type of tire and wheel that is
different from the one that is origi
-
nally installed on your vehicle. It can
affect the safety and performance
of your vehicle, which could lead to
steering failure or rollover and seri
-
ous injury. When replacing the tires,
be sure to equip all four tires with
the tire and wheel of the same size,
type, tread, brand and load-carrying
capacity.
on_en_us.book Page 24 Thursday, January 31, 2019 2:23 PM
To Next Page
Loading...
