Kia 2020 Telluride - Setting and Activating the FCA; Setting the Initial Warning Activation Time

Driving your vehicle
585
Forward Collision-Avoidance Assist (FCA) Sensor
fusion type (front Camera + front radar type)
system
are limited. Pay attention to the
road conditions at all times.
󳱽NEVER drive too fast in accor
-
dance with the road conditions or
while cornering.
󳱽Always drive cautiously to prevent
unexpected and sudden situations
from occurring. FCA does not stop
the vehicle completely and does
not avoid all collisions due to sys
-
tem limitations.
Setting and activating the FCA
The driver can activate the FCA by
placing the ENGINE START/STOP
button to the ON position and by
selecting:
1.Press the MODE button () sev
-
eral times on the steering wheel
until 'User Settings' menu appears
on the LCD.
2.Select 'Driver Assistance → For
-
ward safety' with the MOVE
switch ( / ) and the OK but
-
ton on the steering wheel.
3.Select one of the following
options:
󳱽Active assist: The FCA pro
-
duces warning messages and
warning alarms in accordance
with the collision risk levels.
Also, it controls the brakes in
accordance with the collision
risk levels.
󳱽Warning only: The FCA pro
-
duces only warning alarms in
accordance with the collision
risk levels. You should control
the brake directly because the
FCA system do not control the
brake.
󳱽OFF: The FCA deactivates.
The warning light illumi
-
nates on the LCD display,
when you cancel the FCA.
The driver can monitor the FCA ON/
OFF status on the LCD display. Also,
the warning light illuminates when
the Electronic Stability Control (ESC)
is turned off (Traction & Stability
control disabled.).
When the warning light remains ON
with the FCA activated, take your
vehicle to an authorized Kia dealer
and have the system checked.
Setting the initial warning activa -
tion time
The driver can select the initial
warning activation time in the User
Settings in the instrument cluster
LCD display.
1.Press the MODE button () sev
-
eral times on the steering wheel
until 'User Settings' menu appears
on the LCD.
2.Select 'Driver Assistance → Warn
-
ing Timing' with the MOVE switch
( / ) and the OK button on
the steering wheel.
3.Select one of the following
options:
󳱽Normal: The initial Forward Col
-
lision Warning is activated sen -
on_en_us.book Page 58 Thursday, January 31, 2019 2:23 PM