Kia 2020 Telluride - Warning Message and Warning Light

63
5
5
Driving your vehicleForward Collision-Avoidance Assist (FCA) Sensor
fusion type (front Camera + front radar type)
system
may not operate properly. In this
case, have your vehicle inspected
by an authorized Kia dealer.
󳱽Use only genuine parts to repair
or replace a damaged sensor or
sensor cover. Do not apply paint
to the sensor cover.
󳱽NEVER install any accessories or
stickers on the front windshield,
nor tint the front windshield.
󳱽NEVER place any reflective
objects (i.e. white paper, mirror)
over the dashboard. Any light
reflection may cause a malfunc
-
tion of the system.
󳱽Pay special attention to keep the
camera out of water.
󳱽NEVER disassemble the camera
assembly, nor impact the camera
assembly.
󳱽Do not disassemble the sensor.
󳱽Playing the vehicle audio system
at high volume may prevent you
from hearing the system warning
sounds.
NOTICE
Have the vehicle inspected by an
authorized Kia dealer when:
󳱽The windshield glass is replaced.
󳱽The radar sensor or cover gets
damaged or replaced.
Warning message and warning light
When the sensor cover is blocked
with dirt, snow, or debris, the FCA
system operation may stop tempo
-
rarily.
In this case, a warning message
("Forward Collision-Avoidance Assist
(FCA) system disabled. Radar
blocked") will appear to notify the
driver.
Remove any dirt, snow, or debris
and clean the radar sensor cover
before operating the FCA system.
The system will operate normally
when such dirt, snow or debris is
removed.
The FCA may not properly operate
in an area (e.g. open terrain), where
any substances are not detected
after turning ON the engine.
OON058083NR
on_en_us.book Page 63 Thursday, January 31, 2019 2:23 PM