75
5
5
Driving your vehicleSmart Cruise Control (SCC) with Stop & Go
system
to vehicle distance on the LCD
screen will illuminate.
4.Release the accelerator pedal.
The desired speed will automati
-
cally be maintained.
If there is a vehicle in front of you,
the speed may decrease to maintain
the distance to the vehicle ahead.
On a steep grade, the vehicle may
slow down or speed up slightly while
going uphill or downhill.
NOTICE
Vehicle speed may decrease on an
upward slope and increase on a
downward slope.
CAUTION
When vehicle speed is under 6
mph (10 km/h), the Smart Cruise
Control is canceled. The driver
must adjust the vehicle speed by
depressing the accelerator or
brake pedal according to the road
condition ahead and driving condi
-
tion.
The speed is set to 20 mph (30
km/h) when there is a preceding
car in the front direction, and
when it is set in the situation
where the car is 0 ~20 mph (0~30
km/h).
Increasing the SCC set speed
Follow either of these procedures:
Move the lever up (to RES+), and
hold it. Your vehicle set speed will
increase by 5 mph (10 km/h).
Release the lever at the speed
you want.
Move the lever up (to RES+), and
release it immediately. The cruis
-
ing speed will increase by 1.0 mph
(1.0 km/h) each time you move
the lever up (to RES+) in this man
-
ner.
You can set the speed to a maxi
-
mum speed of 110 mph (170 km/h).
However, all speed limit laws must
be followed.
OON058030NR
To Next Page
Loading...
