Kia 2020 Telluride - Rear Cross-Traffic Collision-Avoidance Assist (RCCA); Setting and Activating the RCCW;RCCA; Setting the Initial Warning Activation Time

Driving your vehicle
1245
Rear Cross-Traffic Collision Warning (RCCW) /
Rear Cross-Traffic Collision-Avoidance Assist
(RCCA) system
Rear Cross-Traffic Collision-Avoid -
ance Assist (RCCA)
The RCCA monitors approaching
cross traffic from the left and right
side of the vehicle when your vehicle
is approaching.
The RCCA may activate the Elec
-
tronic Stability Control (ESC) in cer -
tain situations.
WARNING
󳱽Always be aware of road and
traffic conditions while driving
and be alert for unexpected situ
-
ations even though the Rear
Cross-Traffic Collision Warning
system and Rear Cross-Traffic
Collision-Avoidance Assist system
are operating.
󳱽The Rear Cross-Traffic Collision
Warning system and Rear Cross-
Traffic Collision-Avoidance Assist
system are supplemental sys
-
tems to assist you. Do not
entirely rely on the systems.
Always pay attention, while driv
-
ing, for your safety.
󳱽The Rear Cross-Traffic Collision
Warning system and Rear Cross-
Traffic Collision-Avoidance Assist
system are not substitutes for
proper and safe driving. Always
drive safely and use caution when
backing up the vehicle.
Setting and activating the RCCW/
RCCA
The driver can activate the systems
by placing the ENGINE START/STOP
button to the ON position and by
selecting:
1.Press the MODE button () sev
-
eral times on the steering wheel
until 'User Settings' menu appears
on the LCD.
2.Select 'Driver Assistance → Park
-
ing safety → Rear Cross-Traffic
Safety' with the MOVE switch (
/ ) and the OK button on the
steering wheel.
The RCCA and RCCW is ready to be
activated when 'Rear Cross-Traffic
Safety' is selected.
When the vehicle is turned off then
on again, the systems will be ready
to be activated.
When the RCCW/RCCA is initially
turned on and when the engine is
turned off then on again, the warn
-
ing light will illuminate for 3 seconds
on the outer side view mirror.
Setting the initial warning activa -
tion time
The driver can select the initial
warning activation time in the User
Settings in the LCD display by
selecting:
1.Press the MODE button () sev
-
eral times on the steering wheel
on_en_us.book Page 124 Thursday, January 31, 2019 2:23 PM