Kia 2020 Telluride - Seat Belts - Front Passenger and Rear Seat 3-Point System with Combination Locking Retractor

31
3
3
Safety features of your vehicleSeat belts
Adjusting the height of shoulder
belt
You can adjust the height of the
shoulder belt anchor to one of the 4
positions for maximum comfort and
safety.
The height of the adjusting seat belt
should not be too close to your neck.
The shoulder portion should be
adjusted so that it lies across your
chest and midway over your shoul
-
der near the door and not your neck.
To adjust the height of the seat belt
anchor, lower or raise the height
adjuster into an appropriate posi
-
tion.
󳱽To raise the height adjuster, pull it
up (1).
󳱽To lower it, push it down (3) while
pressing the height adjuster but
-
ton (2).
Release the button to lock the
anchor into position. Try sliding the
height adjuster to make sure that it
has locked into position.
Improperly positioned seat belts can
cause serious injuries in an accident.
WARNING
Shoulder belt positioning
Verify the shoulder belt anchor is
locked into position at the appropri
-
ate height. Never position the shoul -
der belt across your neck or face.
Improperly positioned seat belts can
cause serious injuries in an accident.
WARNING
Seat belt replacement
Replace your seat belts after being
in an accident. Failure to replace
seat belts after an accident could
leave you with damaged seat belts
that will not provide protection in
the event of another collision.
Seat belts - Front passenger and
rear seat 3-point system with
combination locking retractor
The following explains how to fas -
ten the passenger's and rear seat
belt.
Fastening your seat belt:
Combination retractor type seat
belts are installed in the rear seat
positions to help accommodate the
installation of Child Restraint Sys
-
tem. Although a combination
ODEEV058027NR
on_en_us.book Page 31 Thursday, January 31, 2019 2:23 PM