4109
Features of your vehicle
Windshield washers
In the OFF (O) position, pull the lever
gently toward you to spray washer
fluid on the windshield and to run the
wipers 1-3 cycles.
Use this function when the wind-
shield is dirty.
The spray and wiper operation will
continue until you release the lever.
If the washer does not work, check
the washer fluid level. If the fluid level
is not sufficient, you will need to add
appropriate non-abrasive windshield
washer fluid to the washer reservoir.
The reservoir filler neck is located in
the front of the engine compartment
on the passenger side.
CAUTION
• When washing the vehicle, set
the wiper switch in the OFF
(O) position to stop the auto
wiper operation.
The wiper may operate and be
damaged if the switch is set in
the AUTO mode while washing
the vehicle.
• Do not remove the sensor
cover located on the upper
end of the passenger side
windshield glass. Damage to
system parts could occur and
may not be covered by your
vehicle warranty.
• When starting the vehicle in
winter, set the wiper switch in
the OFF (O) position.
Otherwise, wipers may oper-
ate and ice may damage the
windshield wiper blades.
Always remove all snow and
ice and defrost the windshield
properly prior to operating the
windshield wipers.
(Continued)
(Continued)
• When tinting the windshield,
be careful of any fluid getting
into the sensor located in the
top center of the front wind-
shield. It may damage the
related parts.
CAUTION
To prevent possible damage to
the washer pump, do not oper-
ate the washer when the fluid
reservoir is empty.
To Next Page
Loading...
