317
Safety features of your vehicle
Walk-in seat (2nd row seat)
To get in or out of the 3rd row seat:
1. Routing the seat belt webbing
through the rear seat belt guide clip.
After inserting the seat belt, tighten
the belt webbing by pulling it up.
2. Pull up the walk-in lever on the
2nd row seatback.
3. The 2nd row seatback will fold and
the seat will slide forward.
Move the seat to the farthest for-
ward position.
After getting in or out, slide the 2nd
row seat to the farthest rearward
position and pull the seatback firm-
ly backward until it clicks into place.
Make sure that the seat is locked in
place.
Folding the rear seat
The rear seatbacks can be folded to
facilitate carrying long items or to
increase the luggage capacity of the
vehicle.
OHM038031
OHM038022
WARNING
• Never attempt to adjust while
the vehicle is moving or the
2nd row seat is occupied as
the seat may suddenly move
and cause the passenger on
the seat to be injured.
• Do not put your hands under-
neath the seat while adjusting
it.
WARNING
The purpose of the fold-down
rear seatbacks is to allow you to
carry longer objects that could
not be accommodated in the
cargo area.
Never allow passengers to sit
on top of the folded down seat-
back while the vehicle is mov-
ing. This is not a proper seating
position and no seat belts are
available for use. This could
result in serious injury or death
in case of an accident or sud-
den stop. Objects carried on the
folded down seatback should
not extend higher than the top
of the front seatbacks. This
could allow cargo to slide for-
ward and cause injury or dam-
age during sudden stops.
To Next Page
Loading...
