Driving your vehicle
506
To go to the N (Normal) mode, press
the bottom part of the switch. Also, if
the vehicle speed is over 60 km/h
(38mph) or drives over 10 seconds
at the speed of about 45 km/h
(28mph), the vehicle will lower itself
to the N (Normal) mode.
LO (Low) - Loading mode
The rear part of the vehicle is low-
ered to make it easy to load or
unload cargo.
With the engine running press the
bottom part of the switch. The LO
(Low) mode activates only when the
vehicle is not moving. The indicator
blinks when the system is adjusting
itself to the LO (Low) mode. When
the adjustment is completed (about
40mm (2 in.) lowered) the indicator
will illuminate at LO (Low) on the
LCD display.
To go to the N (Normal) mode, press
the top part of the switch. Also, if the
vehicle speed is over 2 km/h (1
mph), the vehicle will lift itself to the
N (Normal) mode.
✽✽
NOTICE
The ALS will adjust the rear height
of the vehicle according to the load
and number of passengers when the
ignition switch is in the ON position
or when the engine is on.
OHM056028L
To Next Page
Loading...
