Kia CADENZA 2020 - Headlights & High Beams; Turn Signals; Heated Steering Wheel

CADENZA FEATURES & FUNCTIONS GUIDE
22
*IF EQUIPPED
Headlights & High Beams
To operate:
• Rotate switch to change the Headlight function
• Push lever to turn High Beams ON
• Pull lever to flash Headlights/High Beams
AUTO Light position — When the light switch is in the AUTO Light
position, the tail lights and headlights will turn ON/OFF automatically
depending on the amount of light outside the vehicle.
High Beam Assist (HBA)
High Beam Assist is designed to automatically adjust the headlight range by
switching between high and low beams based on light from other vehicles
and road conditions.
To enable HBA, go to the audio head unit Vehicle Settings > Vehicle
> Lights > HBA
To activate HBA, toggle the light switch to the AUTO Light position and turn
on the high beams by pushing the lever away from you. The High Beam
Assist indicator will illuminate.
REMINDERS:
• HBA will operate when vehicle speed exceeds 25 mph
• If the lever is pushed away from you while HBA is operational, HBA will turn off and the high
beams will be on continuously. If the lever is pulled toward you while HBA is operational,
HBA flash the high beams
• If the light switch is switched to the headlight position, HBA will turn off and low beams will
be on continuously
Headlight position
Parking light position
AUTO
Auto Light / AFS-R /
High Beam Assist*
OFF
OFF position
Turn Signals
To operate Turn Signals – Move lever Up/Down for Right/Left Turn Signal.
One-Touch Lane Change Signal is activated by moving the Turn Signal
Lever slightly for less than 1 second and then releasing. The lane change
signal will blink 3 times.
To change how many times (3/5/7) the Lane Change Signal blinks, go to
Vehicle Settings in the audio head unit and then Vehicle > Lights
> One-Touch Turn Signal.
For more information on the Vehicle Settings, please refer to the Car Infotainment System Quick
Reference Guide.
Heated Steering Wheel*
While the Engine Start/Stop button is in the ON position, press
B
to turn the
steering wheel heater ON. The button indicator will illuminate.
The steering wheel heater will turn off automatically in 30 minutes, or when
the button is pressed again to deactivate.
One-Touch
Lane Change
Signal
REMINDER: If the steering wheel
becomes too warm, turn the
system off. The heated steering
wheel may cause burns even at
low temperatures, especially if
used for long periods of time.
DRIVE
MODE
R
N
D
P
AUTO
HOLD
VIEW
B
(Button located below gear shift)
STEERING WHEEL CONTROLS