Kia CADENZA 2020 - Homelink with Auto-Dimming Rearview Mirror

43
ALWAYS CHECK THE OWNER’S MANUAL FOR COMPLETE OPERATING INFORMATION AND SAFETY WARNINGS *IF EQUIPPED †LEGAL DISCLAIMERS ON BACK INSIDE COVER
How to Sync Transmitter with HomeLink
®
If programming for the first time, begin with Step 1 (repeating
this step will delete all information).
To program non-rolling and rolling code garage door openers
and other devices:
1. Press and release one of the Homelink
®
buttons. The
indicator light will turn orange
2. Press and hold the desired Homelink
®
button you’re
programming for 15-25 seconds until the orange indicator
flashes several times. Hold the original garage door opener
transmitter approximately 1 to 3 inches away from the
mirror and press and hold the transmitter button. The
HomeLink
®
Indicator light
8
will turn green and flash
rapidly once the frequency signal has been successfully
programmed
To finish programming rolling code garage door openers,
complete these steps:
3. Locate the “learn” or “smart” button on the garage door’s motor head unit. Press and
release the button and complete Step 4 within 30 seconds
4. Firmly press and release the programmed HomeLink
®
button up to three times
Operating HomeLink
®
: Press one of the programmed HomeLink
®
buttons.
Erasing programmed buttons: Press and hold Homelink
®
buttons
1
and
3
simultaneously
for approximately 20 seconds, and then release both buttons within 30 seconds. The indicator
above the Homelink
®
buttons will turn orange for about 10 seconds, then turn green and flash
rapidly.
HomeLink
®†13
with Auto-Dimming
Rearview Mirror
1
Virtual Assist button
2
UVO button
3
Roadside Assist button
4
Homelink
®
Channel 1 button
5
Homelink
®
Channel 2 button
6
Homelink
®
Channel 3 button
7
Garage Door Closing/Closed Status Light
8
Homelink
®
Operation Light
9
Garage Door Opening/Open Status Light
10
Homelink
®
User Interface Light
11
Compass Display
The HomeLink
®
/ Auto-Dimming Rearview Mirror is
designed to reduce glare from a vehicle’s headlights
located in the rear and also connect up to three
electronic transmitters into one location.
REMINDER: Mirror indicator light
8
will illuminate when automatic
dimming is ON.
• You can reprogram a single HomeLink
®
button by repeating Step 2
• Erasing programmed buttons will delete all
trained transmitters
QUICK TIPS
HomeLink
®
Setup
Video
To view a video on your
mobile device, snap this
QR Code or visit the listed
website. Refer to page 2 for
more information.
QR CODE
www.youtube.com/KiaFeatureVideos
If your garage door opener was manufactured in 2011
or later, and you’re unable to program your vehicle’s
HomeLink
®
system, you may need to purchase a
HomeLink Repeater Kit. For more information, go to
www.HomeLink.com or call (800) 355-3515.
SE
11
1 2 3 4 5 6
7 9
8 10
OTHER KEY FEATURES