Kia D9062 ADUP0 - Page 11

Genuine Accessories
N
O
T
E
1. Continue working with Connector C (51 pin connector) on the front side of
the junction block (furthest side from the engine).
N
O
T
E
1. Locate Pin 3 (GRAY w/ ORANGE wire) of Connector C.
29
30
CAUTION: Ensure the correct wire is identified.
NOTE: Factory wire colors are subject to change at any time.
Refer to the pin number to correctly identify the circuit.
Pliers
32
N
O
T
E
1. Attach one (1) T-tap to the wire at Pin 3 (Gray w/ Orange wire).
Use Pliers to snap the T-tap together.
Refer to the Electrical Connection Procedure at the beginning of the
instructions for more details.
N
O
T
E
1. Insert male spade terminal of the mirror harness (Black wire) into the
T-tap connector (Gray w/ Orange wire), for switched ignition power.
Refer to the Electrical Connection Procedure at the beginning of the
instructions for more details.
31
CAUTION: Ensure that the wire is in the slot of the T-tap, and that both
halves of the T-tap are snapped together properly.
CAUTION: Ensure the male spade connector is fully inserted into the wire
tape. Check that the spade did not "miss" the female slot. Check that the
males spade is not visible on either side of the female connector.
Connector C
Pin 3
Grey w/
Orange
T-Tap on
Pin3 Grey
w/ Orange
Black wire
connected
*550-0670-000*
550-0670-000 Rev. 004
Revision Date
11/23/2015
Page 11 of 17