Kia D9062 ADUP0 - Page 5

Genuine Accessories
5
6
Pliers
N
O
T
E
7
N
O
T
E
1. Continue removing the A-pillar trim panel by pulling the top out toward
the passenger side of the vehicle, until remaining one (1) clip is
released.
CAUTION: Do no scratch or damage the A-pillar trim panel.
1. Using a Phillips screwdriver, remove screw as shown above.
2. Grasp the clip, and slide toward the bottom of the A-pillar trim, then pull the
piece out of the trim panel.
1. Using pliers, pull the remaining portion of the A-pillar tether clip out of
the A-pillar, and discard.
CAUTION: Do not damage A-pillar trim panel or headliner.
WARNING: Always use a new tether clip when re-installing the
A-pillar trim panel. Failure to use a new clip may result in serious injury or
death in the event the airbag deploys.
Do not damage the A-pillar trim panel or tether clips.
N
O
T
E
#2 Phillips Screwdriver
#2 Phillips Screwdriver
8
1. Place a new tether clip in the A-pillar trim panel by aligning the slot on
the trim panel with the tether clip.
2. Slide the clip upward until it locks in place.
3. Re-install the retaining plug and screw, removed in the previous steps.
N
O
T
E
*550-0670-000*
550-0670-000 Rev. 004
Revision Date
11/23/2015
Page 5 of 17