17
Emergency Procedures
If previously mentioned methods of disabling the vehicle’s system are unsuccessful, any
emergency procedures involving the electric vehicle may cause the accidental
deployment of undeployed airbags and electric shock from high-voltage components.
5. Remove the safety plug and disable the high voltage battery
(Refer to No.4 procedure in page 15 and cut the HV interlock circuit wiring)
Before engaging in any emergency response procedures, ensure the vehicle is
disabled and wait 5 minutes to allow the capacitor in the high voltage system to
discharge to avoid electrocution.
Exposed cables or wires may be visible inside or outside the vehicle. Never touch
the wires or cables before disabling the system.
Failure to follow these instructions will lead to serious bodily injury or death by
electrocution.
To Next Page
Loading...
