35
5
5
Features of your vehicle Windows
In cold and wet climates, power windows
may not work properly due to freezing
conditions.
The EV button must be in the ON posi
-
tion for power windows to operate.
Each door has a power window switch
that controls the door's window. The
driver has a power window lock button
which can block the operation of rear
passenger windows. The power windows
can be operated for approximately 3
minutes after the EV button is turned off.
However, if the front doors are opened,
the power windows cannot be operated
even within the 3 minute period.
The driver's door has a master power
window switch that controls all the win
-
dows in the vehicle.
If the window cannot be closed because
it is blocked by objects, remove the
objects and close the window.
While driving with the rear windows
down or with the sunroof (if equipped) in
an open (or partially open position), your
vehicle may demonstrate a wind buffet
-
ing or pulsation noise. This noise is a
normal occurrence and can be reduced
or eliminated by taking the following
actions. If the noise occurs with one or
both of the rear windows down, partially
lower both front windows approximately
1 inch (2.5 cm). If you experience noise
with the sunroof open, slightly reduce
the size of the sunroof opening.
Do not install any accessories in the
vehicle that extend into the open win
-
dow area. Such objects will impact the
proper functioning of the automatic
reversal "jam protection" feature.
Window opening and closing
Type A
To open or close a window, press down
or pull up the front portion of the corre
-
sponding switch to the first detent posi
-
tion (1).
Type B - Auto up/down window
(if equipped)
Pressing or pulling up the power window
switch momentarily to the second detent
position (2) completely lowers or raises
the window even when the switch is
released. To stop the window at the
desired position while the window is in
operation, pull up or press down and
release the switch.
If the power window does not operate
normally, the automatic power window
system must be reset as follows:
1. Turn the EV button to the ON position.
2. Close the window and continue pull
-
ing up the power window switch for at
least 1 second after the window is
completely closed.